Difference between revisions of "VioTrack"
(→After the offset calibration check the Lens shift:) |
(→Basic Setup) |
||
| Line 1: | Line 1: | ||
===Basic Setup=== | ===Basic Setup=== | ||
| − | + | # Setup the whole system and read the manual | |
| − | + | # Make sure you have the license activated | |
| + | # Make sure you have the correct lens on your broadcast camera | ||
| + | # Test that you get a stable input from the sensor camera and from the SDI camera (If the sensor camera shows black make sure that the iris is fully opened) | ||
| + | # Check under Test Lens that you get the values for Zoom and Focus | ||
| + | # Adjust the Exposure an Gain of the sensor camera (Exposure <4000, Gain below 10) (Good values are Exposure:2000 and Gain:0 | ||
| + | # Make sure that the sensor camera can see the coded floor at any position | ||
| + | # Make sure that the sensor camera is fixed strongly after the adjustment | ||
| + | # Follow the steps in the Manual or in the Quick manual to do the calibration | ||
===After the offset calibration check the Lens shift:=== | ===After the offset calibration check the Lens shift:=== | ||
Revision as of 14:33, 15 March 2019
Basic Setup
- Setup the whole system and read the manual
- Make sure you have the license activated
- Make sure you have the correct lens on your broadcast camera
- Test that you get a stable input from the sensor camera and from the SDI camera (If the sensor camera shows black make sure that the iris is fully opened)
- Check under Test Lens that you get the values for Zoom and Focus
- Adjust the Exposure an Gain of the sensor camera (Exposure <4000, Gain below 10) (Good values are Exposure:2000 and Gain:0
- Make sure that the sensor camera can see the coded floor at any position
- Make sure that the sensor camera is fixed strongly after the adjustment
- Follow the steps in the Manual or in the Quick manual to do the calibration
After the offset calibration check the Lens shift:
If there is a shifting during the zoom in and out do the following:
- Check the cuboid in the VioTrack software
- Place the cube on the corner of the coded floor
- Fully zoom in and adjust the position again that the edges of the cube perfectly align with the edges of the coded floor
- Zoom full out and in again and check if the cube is shifting
- If there is a shift adjust this shift in the lens Tab with the Lens Shift x & y until there is no more shifting
If there is a shifting during Pan (Left / Right) do the following:
- Adjust the shifting with the Fake FoV value
