Difference between revisions of "Hardware / Networking"
(Created page with "To use {{ot}} with the supported network sensors you have to make sure that the computer which is running the {{ot}} software is in the same network like your connected sensor...") |
|||
| Line 1: | Line 1: | ||
| − | To use {{ot}} with the supported network sensors you have to make sure that the computer which is running the {{ot}} software is in the same network like your connected sensor. | + | ==Network Setup for LAN sensors== |
| + | |||
| + | To use {{ot}} with the supported LIDAR network sensors you have to make sure that the computer which is running the {{ot}} software is in the same network like your connected sensor. | ||
Revision as of 08:23, 17 March 2019
Network Setup for LAN sensors
To use OptiTUIO™ with the supported LIDAR network sensors you have to make sure that the computer which is running the OptiTUIO™ software is in the same network like your connected sensor.
Follow this steps to make sure your computer can see the sensor in the network:
- Open the Network Connections Window
Control Panel\Network and Internet\Network Connections
- Right click on the Network adapter which is connected to the network where your sensor is connected too
- Left click Properties
- Double click Internet Protocol Version 4(TCP/IPv4)
- Give your computer a manual fixed IP and assign the Subnet Mask
|
Make sure that the IP you assign to your computer is not used already from another device! | |||||
|---|---|---|---|---|---|---|
