|
|
| Line 12: |
Line 12: |
| | | | |
| | | | |
| | + | == Content == |
| | | | |
| − | [[VioTrack]] | + | [[VioTrack]] - Camera Tracking System |
| − | | |
| − | Basic Setup:
| |
| − | | |
| − | 1. Setup the whole system and read the manual
| |
| − | 2. Make sure you have the license activated
| |
| − | 3. Make sure you have the correct lens on your broadcast camera
| |
| − | 4. Test that you get a stable input from the sensor camera and from the SDI camera (If the sensor camera shows black make sure that the iris is fully opened)
| |
| − | 5. Check under Test Lens that you get the values for Zoom and Focus
| |
| − | 6. Adjust the Exposure an Gain of the sensor camera (Exposure <4000, Gain below 10) (Good values are Exposure:2000 and Gain:0
| |
| − | 7. Make sure that the sensor camera can see the coded floor at any position
| |
| − | 8. Make sure that the sensor camera is fixed strongly after the adjustment.
| |
| − | 9. Follow the steps in the Manual or in the Quick manual to do the calibration
| |
| − | | |
| − | | |
| − | | |
| − | After the offset calibration check the Lens shift:
| |
| − | | |
| − | If there is a shifting during the zoom in and out do the following:
| |
| − | | |
| − | 1. Check the cuboid in the VioTrack software
| |
| − | 2. Place the cube on the corner of the coded floor
| |
| − | 3. Fully zoom in and adjust the position again that the edges of the cube perfectly align with the edges of the coded floor
| |
| − | 4. Zoom full out and in again and check if the cube is shifting.
| |
| − | 5. If there is a shift adjust this shift in the lens Tab with the Lens Shift x & y until there is no more shifting
| |
| − | | |
| − | If there is a shifting during Pan (Left / Right) do the following:
| |
| − | | |
| − | 1. Adjust the shifting with the Fake FoV value
| |
